COLUMBIA VAC OPC1000N Manual Del Usuario página 26

If the ambient relative humidity increases above 63% RH, the appliance will start dehumidifying to
achieve the ambient relative humidity level below 57% RH.
Then the compressor stops, and the fan will operate for the next 30 s.
The appliance will restart if the relative humidity rises to 63%.
If the ambient relative humidity is below 63%, after connecting the appliance, it stays in the standby
mode until the relative humidity increases to 63%.
Audible signals are off. If the tank overflows, the appliance will stop, and the indicator will illuminate,
but the alarm will not sound.
Standard program
This mode has the default relative humidity setting of 50% RH.
The relative humidity level can be adjusted between 30 - 80% RH as well as the fan speed.
To set the relative humidity level, press the "HUM SET"
selected value in the range 30-80% RH. The relative humidity setting follows the order presented
below: 30% RH - 35% RH - 40% RH - 45% RH - 50% RH - 55% RH - 60% RH - 65% RH - 70% RH - 75%
RH - 80% RH-30% RH etc.
When the ambient relative humidity increases by 3% above the set value, the fan will first turn on,
and then the compressor will start operating.
When the ambient relative humidity drops 3% below the set humidity, the compressor will first stop
operating, and the fan will turn off after about 30 seconds.
Temperature
The appliance has a built-in thermometer. To view the room temperature on the display, press and
hold the "HUM SET" button
Display
- when the appliance is on, it shows ambient humidity,
- when setting the humidity level, it shows the value from the range "30-80",
- when setting the "TIMER" function, it shows values from the range "00-12",
- after pressing and holding the button for about 3 s, it shows ambient temperature.
"SPEED" button
A single press of the "SPEED" sets the fan speed, which is indicated by the indicator lights:
high, - low.
You cannot select the fan speed when the continuous and night programs are activated and when
the buttons are locked.
26
for about 3 s.
- fan speed selection
button until the display shows the
-