Operating Temperature; Automatic Defrosting; Environmental Protection - COLUMBIA VAC OPC1000N Manual Del Usuario

Problem Possible cause
No power.
Water fill indicator is flashing.
The device won't
work
The temperature in the room is below
5°C or above 35°C.
Air filter is clogged.
The dehumidifier
function does not
Door or window is open.
work or the device
The device is near a heat source.
switches on/off
frequently
Inlet or outlet channel is
obstructed.
The device is tilted or unstable.
The device makes
excessive noise
Air filter is clogged.
E2 A problem with the humidity sensor.
The ambient humidity is less than
LO
20%.
HI The ambient humidity is above 95%.
Low temperature protection, ambient
CL
temperature <5°C.
High temperature protection, ambient
CH
temperature >35°C.

OPERATING TEMPERATURE

When the ambient temperature is below 5°C or above 35°C, the dehumidifier stops.

AUTOMATIC DEFROSTING

When the ambient temperature is between 5°C and 18°C, the compressor automatically defrosts at
specified intervals.
During defrosting, the compressor stops and the fan continues to run.

ENVIRONMENTAL PROTECTION

The appliance is made of materials which can be recycled.
It should be handed over to the applicable collection point for the recycling of electrical and
electronic equipment.
WARRANTY
This appliance is designed for domestic use only.
It cannot be used for professional purposes or for other than the intended use.
Improper use will nullify the guarantee.
Solution
Connect to the power socket and switch on.
Check whether the water tank is correctly
installed and empty the water tank
Designed protection tripped
to protect the device. The device cannot
operate at these temperatures.
Clean the air filter according to the instruc-
tions.
Close the door / window.
Place the device in the cooler location.
Remove the obstruction from the inlet or
outlet channel.
Place on an even, hard surface (with no
vibrations).
Clean the air filter according to the instruc-
tions.
Contact the authorized service center.
The automatic device protection function
enabled. Ensure that the device is in proper
working conditions.
29