Toshiba Regza C3000 Serie Manual De Instrucciones página 9

Controls and input connections
A wide variety of external equipment can be connected to the input sockets on the side of the television.
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the television may be used for some functions.
RED LED – Standby
GREEN LED – Power on
GREEN LED – On timer
Switching on
If the RED LED is unlit check that the mains plug is
connected to the power supply. If the picture does not
appear press i on the remote control, it may take a
few moments.
To put the television into Standby press
control. To view the television press
may take a few seconds to appear.
To set up the television you will now need to use the
on-screen menus. Press the MENU button on the
remote control to see the menus.
The menu bar at the top of the screens will show five
different topics shown in symbols. As each symbol is
selected by pressing or
z x
the remote control, its respective options will appear
below.
To use the options, press
e
move down through them and OK,
required choice. Follow the on-screen instructions. The
functions of each menu are described in detail
throughout the manual.
on the remote
i
i again. The picture
on the navigation ring on
on the navigation ring to
or to select the
z x
Using the controls and connections
To alter the volume press –
To alter the programme position press
Press MENU and S, R, P or Q to control the sound
and picture options.
Press MENU to finish.
When connecting sound equipment to EXT3, connect
the audio output of the equipment to the phono sockets
on the television.
To select the Input, press
EXT3 as described on page 23. The television will
automatically sense the type of signal.
Please always refer to the owner's manual of the
equipment to be connected for full details.
Please note: Inserting the headphone plug will mute the
sound from all speakers.
9
Standby
INPUT 3
(EXT3)
+
j .
e e f f .
F
B until the display shows