HOLL'S Alto Vap Instrucciones De Montaje página 15

Maintenance & servicing
Maintenance
IMPORTANT:
Disconnect the cabin's power supply cable before undertaking any work.
Problems identified
Electric stove does not heat up.
Sauna light fitting no longer
work.
Servicing
1. Disconnect your sauna.
2. Use a vacuum cleaner to remove dust from crevices in the woodwork.
3. Clean the cabin with a damp cotton cloth and use a small amount of soap if necessary. Rinse with a damp cloth.
4. Clean the glass with a window / glass cleaner and a soft colth.
IMPORTANT:
Do not use benzene, alcohol, chemical agents or strong detergents on the sauna since chemical products can damage the
wood. Do not spray water on your sauna.
Possible reasons
Power supply cable disconnected.
The general power supply is cut.
Stove is overheat protected.
LED cable not fully plug.
LED is defective.
LED doesn't respond.
Solutions
Check power supply cable connection.
Check that the switchboard and wall plug
are working.
Refer to the electric stove manual.
Plug the cable.
Contact your dealer.
Change remote control batteries.
EN
15