Grill Head to Cart
□ This step requires two people to lift and position grill head onto cart.
□ If not already done, remove the tie wraps and packing material from regulator hose, side
burner valve and igniter wire. Pull hose and igniter wire out to side of grill head.
□ Carefully lower the grill head onto the cart. Make sure the regulator hose and igniter wire are
hanging outside the cart. Open lid and attach head to cart with (4) M6x13 screws and M6
compression washers.
□ Align back rail holes with holes on side panels and firebox. Attach back rail with (4) M4x10
screws.
M6X13 screw
Qty: 4 pcs
M6 compression washer Qty: 4 pcs
M4X10 screw
Qty: 4 pcs
21