Kruger 140 Instrucciones Para El Uso página 16

8
SWITCHING OFF THE MACHINE
- Turn the switch to OFF (Fig. 13).
- Turn off water supply tap.
- Actuate spray gun until water drips from the nozzle
(machine is now de-pressurized).
- Release trigger.
- Press safety latch on spray gun. (Fig.14). The spray
gun is locked and cannot be actuated accidental-
ly.
- Unplug machine from socket outlet.
- Disconnect water supply hose from machine and
water supply mains.
9
ACCESSORIES
Variable nozzle
The nozzle (2 - Fig.1) can be adjusted continuously
by turning the black bushing: from a pinhole jet to
flat jet (Fig.15). Furthermore, you can also change
the pressure from low pressure to high pressure by
turning the grey collar (Fig. 16).
Turbo nozzle (23 - Fig.1 - optional)
The turbo nozzle, is ideal for maximizing cleaning,
cannot be adjusted.
ADDITION OF DETERGENT
The detergents must not be al-
lowed to dry on the object to be
cleaned.
-- Take apart the spraying tube by unscrewing the
locknut of the adaptor (fig. 17A).
- Remove the adaptor by pushing it towards the gun,
rotate by 90º and extract it. (fig. 17B)
- Fill the container of the foam nozzle with suitable
detergent (see paragraph "General safety recom-
mendations" in this booklet) (Fig.18).
- Attach the foaming nozzle on the gun (Fig. 19)
- After using the foaming nozzle insert it in the ap-
propriate slot on the accessory holder (18 - Fig.
1)
10
MAINTENANCE , REPAIRS AND
STORAGE
Before undertaking any
work on the appliance
always detachthe plug from
the power socket
Undertake only the maintenance operations described
in the user instructions.
Contact the Technical Assistance service for all other
interventions.
Use only original spares.
Should the power cable be damaged, it must be repla-
ced by a cable or a set of special cables available from
the manufacturer or its assistance service.
The pins and joints of the connection cables of the electri-
cal system must be protected against accidental water
sprays.
STORAGE
Store the appliance in premises protected against
freezing conditions.
If freeze protection is not guaranteed, suction a glycol
based anti-freeze into the pump, as for cars
- Immerse the water pipe into the container of anti-
freeze
- Immerse the gun without the sprayer nozzle into the
same container
- Insert the appliance with open gun
- Activate the gun until an even jet is obtained.
Store the rest of the anti-freeze in a closed container.
Treatment of waste from electric/electronic
equipment
Dispose of the product in accordance with cur-
rent regulations concerning differentiated waste
disposal in dedicated waste disposal areas. Do
not treat as simple urban waste.
For any information please contact the manufacturer
at the address specified in the user manual.
The product complies with the requirements of the new
directives introduced for the environmental safeguard
and must be disposed of appropriately at the end of
its life cycle.
16