ABC Design Mamba PLUS Instrucciones De Uso página 13

8. Attaching the seat
Attach the seat by placing it on the frame until it clicks into place.
To remove the seat, pull the levers on both seat unit adapters and lift up the seat.
9. Attaching the hood
a. Remove the hood
b. To fit the hood cover you must first remove the hood holder on one side by pulling back the
lever on the hood holder.
You can press the lever outwards from the inside using a screwdriver or another pointed
object.
c. Pull out the hood cover from the open side.
d. To attach the hood cover, you must thread it through the open side.
e. Then you can push on the hood holder.
f. Fit the hood on the seat frame with the two plastic brackets.
10. Fitting and removing the guard rail
Fit the guard rail by inserting it in the plastic mounts on both sides.
To remove the guard rail from the pushchair, press in the buttons on both sides and pull the guard rail off
away from the pushchair.
11. Adjusting the leg rest
a. To adjust the leg rest, press in the buttons on both sides and then adjust the height.
Let go of the buttons again so that the leg rest clicks into place.
b. In order to adjust the length of the footrest, it is necessary to undo the snap fasteners on the footrest
cover first. It is then possible to press in the buttons on both sides of the footrest and to adjust the length.
The fabric cover can then be fastened again.
12. Fastening the harness
To fasten the harness, bring the top two plastic catches together and interlock them.
Then insert the interlocked catches into the bottom part of the fastening.
Adjust the harness to a setting where the baby is held in the correct position.
13. Unfastening the harness
To open the harness, press the button on the side.
CAUTION: Always use the shoulder harness and lap belt together.
14. Adjusting the seat angle
To adjust the angle of the seat unit, press and hold down the buttons on both sides of the seat unit and
move the seat to the required position. When the required position is reached, let go of the buttons to allow
the seat to click into that position.
EN - 07