Promax DT-802 Manual De Instrucciones página 69

CONTROL MODULE. DT-802
The automatic position assignment does not have any practical effect. Each time
you restart the DTTV, the control module will assign different positions to each module.
If you do not like this way to assign, Then you can create and save your own assigment.
In this way, your assigment will remain unchanged.
Verify that the modules appearing in the list correspond with the installed and its
status is OK.
Note that dual modules, such as the DT-102 or DT-302, are treated as two
separate units that must be configured independently.
In contrast, the module DT-7XX, will not appear on the list even if they are
installed in the headend.
If there is some problem, it will appear the name of the module in the STATUS
line and in the line below a brief description of the problem (Fig. 10.-).
If there are more than one module working wrong, the names of these module will
appear sequentially at the bottom of the screen. Next to the name is shown a number
indicating the order of the module for total modules with errors.
If any of the modules is not listed or its status is not OK, check the connections,
especially the control and power cord, which is what connects the control unit with the
modules, and by which is transmitted the power supply and the identification data and
settings.
If the problem persists, adjust the settings or contact our customer service.
If you want to pass to the setup menu, enter the password and press ENTER
.
The system has a "TIME OUT", which makes the screen again, after a certain
time without touching any keys.
04-2015
Figure 10.- Errors in the Main Screen.
Page 17