Miele 09079450 Instrucciones De Montaje página 35

Produktgruppe 512
35 von 36
Check existing wiring:
Check that the blue wire from module 1 (liquid dispensing 1-6) EZL 235
see Fig. 2, Pos. 6
Modify existing connections:
Disconnect the plug from module 1 EZL 235
see Fig. 2, Pos. 1.
Connect the screw terminals:
Connect the green 7-pin screw terminal to module 2 (liquid dispensing 7-12) EZL 235
Connect the blue 6-pin screw terminal to module 2 (liquid dispensing 7-12) EZL 235
Arrange and connect the wiring harnesses:
Warning!
The load and control current wiring harnesses should be separated from one another to prevent noise in the control circuit
(electromagnetic tolerance).
Extra wiring should be laid in the opposite direction to avoid antenna-like behavior.
Connect load current wiring harness 20X-41X from module 2 (liquid dispensing 7-12) EZL 235
dispensing 1-6) EZL 235
Connect control current wiring harness N1Q_ST112, N1Q_ST11 from module 2 (liquid dispensing 7-12) EZL 235
module 1 (liquid dispensing 1-6) EZL 235
Connect electronics ELZ 235 module 2 and ELZ 235 module 1 in accordance with the wiring diagram.
Connect the coded plugs:
Connect coded plug MFM 2-5 to module 2 (liquid dispensing 7-12) EZL 235
Register module 2 (liquid dispensing 7-12):
Service Settings Register module EZL with coding 2 Register module? OK Diskette symbol to save the registration.
Switch on dispensing display.
Service Settings Basic settings Dispensing Dispensing display: Off
symbol to save display activation.
Note
Switching on the dispensing display enables the operator to select and deselect dispensing. Without dispensing display, only
information regarding whether dispensing is active and the dispensing amount is shown.
To quit service mode, switch the machine off.
Connect and calibrate the dispensing pump:
Knock out the pre-punched hole on the machine rear panel.
Install the cable guide on the rear panel; see Fig. 3.
Connect the dispensing pump in accordance with the wiring diagram.
06.02.2014 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
ST9 and connect it to module 2 (liquid dispensing 7-12) EZL 235
ST9; see Fig. 2, Pos. 3a.
ST112; see Fig. 2, Pos. 3b.
Umbau- und Montageanweisung
ST8, pin 7 is wired correctly to terminal strip 3X3-4 (blue);
ST8; see Fig. 2, Pos. 2a.
ST12; see Fig. 2, Pos. 2b.
ST10 to module 1 (liquid
ST3, pin 2-5; see Fig. 2, Pos. 4.
On OK Back (to go back one level) Diskette
M.-Nr. 09087211
ST9;
ST111 to