Friedrich M18YJ Manual De Instalación página 16

16
Finishing the indoor unit
installation
1
Mount the tubing holder in the original posi-
ton.
2
Ensure that the hooks are properly seated
on the installation plate by moving it left
and right.
3
Press the lower left and right sides of the
unit against the installation plate until the
hooks engage into their slots (clicking
sound).
4
Finish the assembly by screwing the unit to
the installation plate by using two pieces of
type "C" screws. And assemble a chassis
cover.
Type 'C' screw
CAUTION
!
• Before finishing installation of the indoor
unit, seal the hole of a wall except the
pipe's ways to prevent condensate from
inflow of outdoor air.
Outdoor unit
Connecting the Piping
- Remove the tubing cover from the unit by
loosening the screw.
- Align the center of the pipings and sufficiently
tighten the flare nut by hand.
Terminal Block
Cover
control
Tubing
Cover