Introduction; Equipment; Technical Data - ESAB Mig 410 Origo Instrucciones De Uso

GB
3

INTRODUCTION

TM
The Origo Mig 410 and Origo
designed for MIG/MAG--welding together with wire feed units Origo
TM
Origo Feed 48x and the most of ESAB wire feeders.
The power units are fan--cooled and equipped with thermal overload protection.
ESAB's accessories for the product can be found on page 47.
3.1

Equipment

The power source is supplied with:
Shelf for gas cylinder
S
Guide pin for wire feed unit
S
Instruction manual
S
4

TECHNICAL DATA

Voltage
Permissible load
at100 % duty cycle
at 60 % duty cycle
at 50 % duty cycle
Setting range (DC)
Open circuit voltage
Open circuit power
Efficiency at max current
Power factor at max current
Control voltage
Dimensions lxwxh
Weight
Operating temperature
Enclosure class
Application classification
Duty cycle
The duty cycle refers to the time as a percentage of a ten--minute period that you can weld at a cer-
tain load without overloading.
Enclosure class
The IP code indicates the enclosure class, i. e. the degree of protection against penetration by solid
objects or water. Equipment marked IP23 is designed for indoor and outdoor use.
Application class
The symbol indicates that the power source is designed for use in areas with increased
electrical hazard.
mi410,510e
TM
Mig 510 are step switched power sources
TM
Origo Mig 410
230/400--415/500V 3∼ ∼ ∼ ∼ 50 Hz
230/440--460 3∼ ∼ ∼ ∼ 60Hz
280 A/28 V
365 A/32 V
400 A/34 V
50A/16,5V--400A/34V
17--45 V
360 W
71%
0,98
42 V, 50/60 Hz
812 x 552 x 925
145 kg
o
--10 to +40 C
IP 23
- - 6 - -
TM
Feed 30x,
TM
Origo Mig 510
230/400--415/500V 3∼ ∼ ∼ ∼ 50 Hz
230/440--460 3∼ ∼ ∼ ∼ 60Hz
390 A/33,5 V
500 A/39 V
--
50A/16,5V--500A/39V
17--50 V
440 W
82%
0,92
42 V, 50/60 Hz
812 x 552 x 925
215 kg
o
--10 to +40 C
IP 23