Instructions For Use - Flex FHE 2-22 SDS-plus Instrucciones De Funcionamiento Originales

FHE 2-22

Instructions for use

Before switching on the power tool
Unpack power tool and accessories and
check that no parts are missing or damaged.
Adjusting the auxiliary handle
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
CAUTION!
Use electric power tool with attached
auxiliary handle only.
The auxiliary handle can be swivelled into
any position to ensure safe and fatigue-free
working.
 Loosen the clamping by turning
the clamping screw anti-clockwise.
 Swivel the auxiliary handle into
the required position.
 By turning the clamping screw clockwise,
fix the handle in the required position.
Attaching the depth stop
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
 Loosen the clamping screw by turning
it anti-clockwise.
 Push in depth stop.
 Set depth stop to the required drilling
depth.
 Tighten the clamping screw clockwise.
Inserting tools with SDS shank
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
CAUTION!
Used insertion tools may become hot.
Wear protective gloves!
NOTE!
Tools used must have an SDS shank.
If tools do not have an SDS shank
(e.g. wood drill bit), a three-jaw chuck
must be used.
 Check dust cap.
– Clean dirty cap.
– Have a defective dust cap replaced.
15