Hama 00090917 Instrucciones De Uso página 23

Bluetooth:
Configuring the Bluetooth function of the
digital picture frame
1.) Activate the Bluetooth function of the digital picture
frame as follows:
• Main menu -> Setup -> Factory settings -> Bluetooth
on/off -> ON
The Bluetooth function of the digital picture frame is
now activated.
2.) Activate the Bluetooth-enabled device (mobile
phone, PC, etc.) which you intend to use.
Configure/activate the Bluetooth mode according to
the operating instructions of the device.
3.) Have your device search for existing Bluetooth
connections. The digital picture frame is detected as
either "Digi Frame" or "Amlogic".
4.) Enter "0000" when prompted to enter the PIN.
5.) As soon as the display indicates that a connection
has been established properly, you can begin to
transfer data via the Bluetooth connection to the
internal memory of the digital picture frame. You may
also have to follow other instructions of the transfer
device (e.g. mobile phones or PCs) (see the
instructions of the transfer device).
Note:
Note that not all Bluetooth devices are compatible
with one another (depends on profiles and internal
passwords).
Caution:
To connect USB devices to the digital picture frame
with a standard type-A USB connector, carefully pull
the Bluetooth dongle out of the USB port. In this case,
please keep the Bluetooth dongle in a safe place
so that you do not lose it.
The enclosed Bluetooth dongle is available separately
under Hama item no.: - 49227: "Nano Bluetooth
dongle". The current driver for the dongle can be
downloaded from the Hama Internet site (www.hama.de/
www.hama.com). It allows you to install the enclosed
Nano Bluetooth dongle on other devices (e.g. on a PC,
laptop, etc.) to enable Bluetooth support.
24
Configuring the Bluetooth connection via a PC/laptop
Please follow steps 1.) to 5.) mentioned above to
establish the Bluetooth connection between your
PC/laptop.
6.) Now select the photo/file to be transferred and begin
transfer (see example below).
7.) Your PC/laptop now attempts to connect to the
digital picture frame.