Perel LEDS12CWW Manual Del Usuario página 6

5. Remote Control Overview
Refer to illustration [B2] on page 3 of this manual.
1 on/off
2 reset cold and warm white to 100 % intensity
3 colour temperature adjustment
4 quick colour temperature adjustment
5 dimming
6 cold and warm white flash function
7 speed setting
6. Installation
Guidelines
 Avoid installing the LED strips near heat sources such as ovens,
toasters, etc.
 Never use the LED strip when it is coiled up as this can cause
overheating.
 Before mounting, ensure the desired surface is flat and clean of
any grease, dirt or debris.
 Avoid tight bends in the LED strip.
 Observe the correct polarity when re-joining cable sections. The
polarity is marked at regular intervals along the LED strip.
 Cut the strip using sharp scissors or a craft knife with a fresh
blade. Cut directly on the marked line. Never cut the LED strip
when it is pugged in.
Installation
Refer to the illustrations on page 2 of this manual.
1. Mount the LED strip in the desired location. The LED strip can be
cut every 10 cm (see [A1]). Protect the cut ends to avoid short-
circuits.
2. Connect the LED strips to the controller (see [A2]). Make sure
to connect matching wire colours and do not short-circuit any
wires. Connecting tools are not included.
V. 03 – 22/11/2017
LEDS12CWW
6 ©Velleman nv