Franke FMA 2.0 607 Manual De Uso página 10

Ocultar thumbs Ver también para FMA 2.0 607:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 24
4. CONTROLS
Button Function
A
Press briefly to turn the Motor on (speed one)/off.
Press and hold the button for approximately 2 seconds,
with the filter alarm active, to reset the alarm.
B
Decreases the working speed.
With the motor turned off, press and hold the button
for approximately 2 sec. to activate/deactivate the
keyboard lock, allowing the glass to be cleaned without
activating any of the functions by mistake. It deactivates
automatically after 2 minutes.
C
Increases the working speed in cycle..:
1 - 2 - 3 - Intensive
Intensive: Timed to run for 6 minutes, after which it
returns to Speed 3.
They are disabled by pressing A or B.
D
Press briefly to enable/disable the Delay, automatic
switch-off of the Motor and Lighting system with a 30
minute delay. It can also be deactivated by pressing A.
Press and hold the button for approx. 2 sec. to Activate/
Deactivate the motor in 24H Air Circulation mode, a speed
that allows ducting for 10 minutes every hour, for a 24
hour cycle. It can also be deactivated by pressing A.
E
Turns the lighting system on and off at medium intensity. On/Off
F
Turns the lighting system on and off at maximum intensity. On/Off
5. LIGHTING
• For replacement contact technical support
("To purchase contact technical support").
10
Display
Shows the speed set.
Leds C + D flash 3 times.
When the procedure terminates, the indication shown
previously turns off:
F - 1 + (pause) + F - 1
Indicates that it is necessary to wash the metal
grease filters. The alarm is triggered after the Hood
has been operating for 100 working hours.
F - 2 + (pause) + F - 2
Indicates that it is necessary to change the activated
charcoal filters and wash the metal grease filters
at the same time. The alarm is triggered after the
Hood has been operating for 200 working hours.
Shows the speed set.
All the Leds flash every half a second.
Shows the speed set 1 - 2 - 3 .
Shows " animation " on the display.
On/Off + " animation " on the display.
Flashing + " animation " on the display.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Fma 2.0 807Fma 2.0 907

Tabla de contenido