Adjusting Depth Of Cut; Bevel Cutting - Makita DHS711 Manual De Instrucciones

Adjusting depth of cut

1
► 1. Lever
CAUTION:
• After adjusting the depth of cut, always tighten
the lever securely.
Loosen the lever on the depth guide and move the base
up or down. At the desired depth of cut, secure the base
by tightening the lever.
For cleaner, safer cuts, set cut depth so that no more
than one blade tooth projects below workpiece. Using
proper cut depth helps to reduce potential for danger-
ous KICKBACKS which can cause personal injury.

Bevel cutting

► 1. Front lever
Loosen the front lever. Set for the desired angle
(0° - 50°) by tilting accordingly, then tighten the lever
securely.
► 1. Stopper
Use the 45° stopper when you do precise 45° angle
cutting. Turn the stopper clockwise fully for bevel cut
(0° - 45°) and turn it counterclockwise for 0° - 50° bevel
cuts.
Sighting
1
► 1. Cutting line (0° position) 2. Cutting line (45°
position)
For straight cuts, align the 0° position on the front of
the base with your cutting line. For 45° bevel cuts, align
the 45° position with it. The position of the top guide is
adjustable.
8 ENGLISH
0-45 0-50
1
2
1