HoMedics BPA-200 Manual Del Usuario página 9

3. Remove tight fitting clothing from around your
upper left arm.
4. Position cuff edge 0.8-1.2
inches (2-3cm) above elbow.
5. Center tube over middle of arm.
6. Pull the end of the cuff so that it tightens
evenly around your arm.
Press the hook
and loop material together to secure.
Allow room for 2 fingers to fit between
the cuff and your arm.
7. Lay your arm on a table (palm upward) so the cuff is
at the same height as your heart. Make sure the
tube is not kinked.
15
Note:
If it is not possible to fit the cuff to your left arm, it
can also be placed on your right arm. However, all
measurements should be made using the same arm.
To use on the right arm, you must position the artery
symbol " " over the main artery. Locate the main
artery by pressing with two fingers approximately 1"
(2 cm) above the bend
of your elbow on the
inside of your right arm.
Identify where the pulse
can be felt the strongest.
This is your main artery.
Very Important: Proper cuff size is critical to accurate
measurement. This cuff is suitable for your use if
Artery M
the arrow falls within the solid color line as shown
below. If the Arrow falls outside of the Solid Color Line,
you will need a cuff with other circumferences. Contact
HoMedics Consumer Relations regarding additional
cuff sizes.
Art
OK RA
Arrow
Main Artery
One Size
Cu Fits:
8.7-18.1 Inches
22-46 Centimeters
Latex free
Model# PP-BPCUFF7
Solid Color Line
Center tube
over middle
of arm
16