Maintenance; Troubleshooting Table - BAT 2040 Manual Para Uso Y Mantenimiento

Use and maintenance manual
Pic. 6 OPENING: Fabric stretched
to its maximum extension.
See the instructions provided in the remote control manual annexed.
· Use a lockable (key) switch if the structure is to be installed in sensitive locations such as schools,
colleges, hospitals, rest homes etc.
· If the product is fitted with a remote control, this must be kept out of the reach of children.
The remote control may also be used outdoors, as long as the system has an IP rating of IP55 or higher.
The space made available during the installation must take into account the space required for the movement
and allow the product to open fully.
· No ladders or other fixed objects must be installed or positioned near the product, such that the
spaces it needed are reduced.
The characteristics and operation of these systems are described in the manuals, which are supplied as annexes,
for the requested controls, motor and automatic devices.
In the event of faults or malfunctions, contact your reseller.
5

Maintenance

· MAINTENANCE ON ELECTRICAL PARTS MUST ONLY BE PERFORMED BY QUALIFIED
PERSONNEL
· All maintenance and cleaning operations must be performed with the electrical supply disconnected.
·There is the danger of deadly electrical charges over the course of the research or of the restoration
of potential mulfunctions in the electrical part.
· Before operating the structure, read instructions in Ch.Pt.2 "Safety", P. 21 carefully.
· The operations of assembly of the components, installation and first start of the product must only
be performed by specialised and qualified technicians, and is the responsibility of the reseller and/or
manufacturer.

5.1 Troubleshooting Table

· All safety requirements must be followed in the event of faults or troubleshooting.
For faults and errors not listed in the following tables, contact Technical Support.
MANUAL AWNING
PROBLEM
Fabric does not roll up evenly (forms
cone)
06/09/2019 Rev.05
Pic. 7 STOP: Stop of the move-
ment.
CAUSES
Incorrect alignment of arms
Gust of wind
2040
Pic. 8 CLOSURE: Fabric wrapped
around roller tube.
SOLUTIONS
Contact Technical Support
Unroll the fabric and eliminate any folds
25