Use and maintenance manual
performed after the initial installation, is not covered by warranty.
The packaging material must be disposed off and/or recycled according to the applicable local legislation.
7.2 Installation
·Assembly of the components, installation and first start of the product must only be performed by
specialised and qualified technicians, and is the responsibility of the reseller and/or manufacturer.
· It is recommended to use protective gloves so as not to damage the blinds.
All the instructions and the main safety standards to perform these operations are described in the "Assembly
Manual" and the "Installer Manual".
The position chosen by the user for the installation of the product must provide adequate support as well as the
space necessary for the structure to open fully (see "Installer Manual").
8
Disassembly and Disposal
· The product must be removed and disassembled by trained and qualified personnel, in compliance
with health and safety legislation. Request specialist assistance from Technical Support.
Operations must be performed with the product completely closed.
Cut the power supply to the system by disconnecting the circuit that supplies the switch, disconnect the motor,
open the support brackets and remove the structure from them.
No materials considered hazardous have been used in the product; there are no particular instructions for its
disposal or scrapping.
Follow applicable legislation in force when the product is removed for its disposal.
9
Optional
9.1 Safety devices
The product can provide on request:
(only in motorized models)
•
WIND SENSOR: automatically closes the awning in the event of strong wind. The set point for the wind sensor
(anemometer) operation is recorded during the first-start procedure described in the Installer Manual.
•
RAIN GAUGE automatically closes the awning in the event of prolonged rain. The set point for the rain gauge
(pluviometer), which measures the amount of rain which has fallen in a given period of time, is recorded during
the first-start procedure described in the Installer Manual.
•
TWILIGHT SENSOR: when the ambient light level decreases, the electrical circuit automatically closes the
awning.
•
EMERGENCY CRANK: in the event of a power cut, it is possible to roll up the awning thanks to the presence
of an emergency manual crank.
•
LED STRIP LIGHT KIT.
·The protection systems may be ineffective in particular climatic conditions.
·The sensors should not be considered safety devices that can prevent damage to the product caused
by strong wind (indeed a power cut would make it impossible to automatically wind up the blinds).
·The sensors are part of the automation system which helps protect the product and facilitates its use.
· The manufacturer does not accept responsibility for any material damage caused due to atmospheric
effects not detected by the device sensors.
The characteristics and operation of these optional accessories are described in the manuals, supplied as
annexes, concerning requested controls, motor and automatic devices.
Installation is described in the "Installer Manual".
06/09/2019
Rev.05
2040
29