Getting To Know Your Unit; Set Up Instructions - Campbell Hausfeld XT002000 Manual De Instrucciones

GETTING TO KNOW YOUR UNIT

Anvil

SET UP INSTRUCTIONS

* Items shown in Set Up Instructions are not included with this tool.
◆ The air compressor used with your impact wrench must be able to maintain a
minimum of 90 PSI when the tool is being used. An inadequate air supply can
cause a loss of power and inconsistent tool output/performance.
A pressure regulator—used at the tool--is helpful to control the operating pressure
◆
of the tool and maintain 90 PSI.
◆ Use an oiler to provide oil circulation through the tool and a filter to remove liquid
and solid impurities which can rust or "gum up" internal parts of the tool.
◆ To disconnect a coupler/plug from a system set-up: push the coupler and plug
together before pulling the coupler sleeve back and separating the coupler and
plug.
◆ Use only sockets specifically rated as "impact" drive sockets. Non-impact drive
sockets—if used with air tools—can shatter causing serious personal injury.
Trigger
Exhaust Port
Air Hose
BEST PRACTICES
3
Air Inlet
Plug
Quick
Coupler
Forward-Reverse
Dial/Air-flow
Regulator