Programming The Remote - Sony Wega KDE-W50A11E Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

To connect
Do this
Conditional Access
To use Pay Per View services.
Module (CAM) C
For details, refer to the instruction
manual supplied with your CAM.
To use the CAM, press the eject
button and remove the "dummy"
card. Switch off the TV when
inserting your CAM into the CAM
slot. When you do not use the
CAM, we recommend that the
"dummy" card be inserted and
kept in the CAM slot.
Modem connector
This feature is not supported on
D
this TV.
DVD player with
Connect to the component sockets
component output
and the audio sockets
E
The component signal containing
576p signal format and audio
signal are input from the DVD
player.
Digital satellite
Connect to the HDMI IN 5 socket
receiver or DVD
if the equipment has a HDMI
player F
socket. The digital video and audio
signals are input from the digital
satellite receiver. If the equipment
has a DVI socket but not an HDMI
socket, connect the DVI socket to
the HDMI IN 5 socket through a
DVI - HDMI adaptor interface (not
supplied), and connect the
equipment's audio out sockets to
the audio in HDMI IN 5 sockets.
The digital video and analogue
audio signals are input from the
equipment.
"PlayStation 2",
Connect to the scart socket
DVD player or
1. When you connect the
decoder G
decoder, the scrambled signal from
the TV tuner is output to the
decoder, then the unscrambled
signal is output from the decoder.
In this case, it will be properly
unscrambled if you set "AV2
Output" to "TV Analog"
(page 29).
DVD recorder or
Connect to the scart socket
VCR that supports
2. SmartLink is a direct link
SmartLink H
between the TV and a VCR/DVD
recorder. For more information on
SmartLink, refer to the instruction
manual supplied with your VCR or
DVD recorder.
VCR I
For details, see page 11.
Hi-Fi audio
Connect to the audio output
equipment J
sockets
from the TV on Hi-Fi audio
equipment. To turn off the sound
of the TV speakers, set "Speaker"
to "Off" (page 28).
/
4.
/
/
to listen to the sound
Programming the
remote
This remote is preset to operate Sony TVs, most Sony
DVDs, VCRs and AUX systems (DAV, DTT
Receiver, Home Theatre, etc.).
To control VCRs and DVDs of other manufactures
(and some other Sony VCR, DVD and AUX models),
do the following procedure to programme the remote.
Note
Before you start, look up the three-digit code for your brand
of DVD, VCR or AUX system from the "Manufacturer's
codes" on page 42.
1
To programme VCR or DVD:
Press and hold
until the green VCR and DVD lights flash.
To programme Sony AUX systems:
Press and hold
until the green AUX light flashes.
2
While the relevant lights are flashing, press
the number buttons to enter all three-digits
of the code for your brand of equipment
(page 42).
The green light is lit momentarily.
3
Turn on your equipment and check that the
following main functions work.
N (playback), x (stop), m (rewind), M (fast
forward), channel selection for both VCR and
DVDs, MENU and M/m/</, buttons only for
DVDs.
1
2
for about six seconds
for about six seconds
Continued
41
GB

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido