Solar BA227 Manual Del Usuario página 10

NORMAL – Charging System OK
LOW – Charging Voltage is Low – Alternator is not providing sufficient current
for the system's electrical loads and to charge the battery. Check belts and
connection from alternator to battery.
HIGH – Charging Voltage is High – Voltage output from alternator to battery
exceeds the normal limit. Check alternator connections, including ground
connection. Also, check manufacturer specifications, as output may vary by
vehicle type and manufacturer.
14. Press "ENTER" to go to the Print Option Screen. The tester will ask if you would
like to PRINT RESULT? Scroll to your preferred choice and press "ENTER". If
you chose YES, the printer will print results. If you chose NO, the tester will once
again return you to the Home Screen and once again display the battery's open
circuit voltage.
15. Turn engine OFF and remove the test leads from the battery posts after
completion of testing, always removing the negative clamp first and then the
positive clamp.
Counter Function
The tester is equipped with a counter function that allows you to track the number
of tests performed over time. The counter can be accessed through the
Configuration Screen. From the Home Screen, scroll to CONFIGURATION
and press "ENTER" to go to the Configuration Screen. To access the counter, scroll
to COUNTER and press "ENTER". The tester will show the counter display, listing
the number of battery tests and the number of system tests that have been
performed since the unit was first configured or last reset.
From the counter display, press "ENTER" to achieve the following next steps: return
to the Home Screen, reset the counter or print the counter result. The first choice
shown will be RETURN TO BATTERY TEST. Selecting this option will return you to
the Home Screen.