Makita AN610H Manual De Instrucciones página 8

Wood thickness
(mm)
20(3/4")
25(1")
30(1-3/16")
35(1-3/8")
009199
1
009190
CAUTION:
Use this tool only for soft concrete built up not so
•
long before. Using on the hard concrete may cause
nail bending or nailing to insufficient depth.
When the penetration amount into concrete comes
•
to more than 15 mm (5/8"), nailing to the sufficient
length may not be obtained.
Cutting off the sheet
009183
CAUTION:
Always disconnect the hose before cutting off the
•
sheet.
Tear off the output sheet in the direction of the arrow
when using the sheet collated nails.
MAINTENANCE
CAUTION:
Always disconnect the air hose from the tool before
•
attempting to perform inspection or maintenance.
Nail length Concrete
(mm) (mm)
32(1-1/4") Approx. 12(1/2")
38(1-1/2") Approx. 13(1/2")
45(1-3/4") Approx. 15(5/8")
50(2") Approx. 15(5/8")
1. Nail length
2. Wood thickness
3. Concrete range
2
10 mm (3/8") -
15 mm (5/8")
3
Jammed nailer
009184
009185
CAUTION:
Always disconnect the air hose and remove the
•
nails from the magazine before cleaning a jam.
When the nailer becomes jammed, do as follows:
Open the magazine cap and remove the nail coil. Insert
a small rod or the like into the ejection port and tap it with
a hammer to drive out the nail jamming from the ejection
port. Reset the nail coil and close the magazine cap.
Drain tool
Remove the hose from the tool. Place the tool so that
the air fitting faces down to the floor. Drain as much as
possible.
Cleaning of tool
Iron dust that adhere to the magnet can be blown off by
using an air duster.
Cap
When not in use, disconnect the hose. Then cap the air
fitting with the cap.
009193
Storage
When not in use, the nailer should be stored in a warm
and dry place.
Maintenance of compressor, air set and air hose
8
1. Small rod
1
1. Screwdriver
1
1. Cap
1