Lenco L-90 Manual Del Usuario página 7

2. Getting started
Keep the turntable out of direct sunlight. When the turntable is not in use, place it on a sturdy
platform of which the surface should be flat and steady, so the turntable cannot fall. Make sure the
turntable is stored in such a manner that no object can fall on it, as pressure will damage or break
the turntable. Prevent insertion of small objects into the ventilation slots, or openings in the cabinet
at all time.
Installation of the turntable
Open the box and unpack all parts.
1.
Put the platter on the turntable and mount the belt. The belt is on the
2.
downside of the platter.
Install the cartridge by placing it on the tone arm and turn the tone
3.
arm's anti-skate corkscrew until the cartridge is fixed.
Mount and set the counterweight.
4.

Screw the counterweight on the tone arm.

Unlock the tone arm.

Remove the protective cover of the stylus. Make sure you do not touch the stylus, nor that
the stylus touches anything.

Lift the tone arm from the armrest and lower the armrest.

Move the counterweight carefully a little either to the left or to the right until the tone arm
is in balance and floats horizontally.

Bring the tone arm back to the armrest and lock the armrest in such a manner that the tone
arm cannot move during installation.

Move the black plastic part of the counterweight to 0. The 0 should be in line with the red line
on the tone arm. Be careful that you do not move the metal part.

Turn the metal part to the left to increase the needle pressure. Lenco recommends to set the
needle pressure to 3.
Set the anti-skating. Lenco recommends that the anti-skating should about half the needle
5.
pressure, for the best result try different settings yourself.
Place the hinges and mount the dust cover.
6.
Connect the AC cable to the wall outlet.
7.
Connect the line out cables to a mixer or HiFi system.
8.
Important note: This turntable has a built-in amplifier to avoid
damage on the turntable or your audio-system. Do not connect this
turntable to your audio-system by using the phone-input because
this input is also amplified.
7