Manual Cleaning; Technical Specifications - Bominox LACTIC Serie Instrucciones De Instalación Y Mantenimiento

Bomba centrífuga higiénica
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
The cleaning cycles must be repeated immediately after finishing the production cycle in the food
industry with the aim of eliminating organic compound deposits such as proteins, carbohydrates, fats,
minerals and others, which are the basis for bacterial growth.
At the safety level, sealing on the entire circuit and its connections must be ensured, as well as on the
pump and it is sealing system. It is also recommended that the pump is in operation during the process.

1.5.2 Manual cleaning

Or manual clean the body, impeller and other elements through to the pump's mechanical seal must be
disassembled. For disassembly see section 4 (Maintenance).
Always use the appropriate protection equipment for carrying out this task.
Do not clean the pump manually when it is in operation. First disconnect the start-up
system.
2

Technical specifications

Temperature range
Maximum pressure
Maximum rotation speed
Maximum viscosity
Materials
Motors
3
Start-up
The user is responsible for safe use of these appliances in accordance with these technical
instructions as well as, if any, the specific technical documentation of the appliance
supplied.
3.1 Location
Place the pump as close as possible to the liquid supply point.
Install it in a wide space with easy access, with good ventilation and if possible with low temperature.
Try not to install the pump on damp floors or where corrosive liquids can easily reach. In such case
isolate from the floor with a base or other elements.
If the pump must be installed outdoors, it must be under a roof.
3.2 Tubes
For optimal operation of the pump, the suction and discharge tubes must be totally hermetically sealed.
This is essential for the suction tube because if air enters through a crack or pore the performance is
considerably lower until the pump is primed.
If the pump needs to suction from a lower level, ensure that the tubing is always in ascending mode in
order to avoid air pockets.
Try to reduce the number of elbows, valves or obstructions as much as possible as these can cause
significant load losses.
The recommended speed of the liquid through the suction tube must be a maximum of 2 m/s.
It is recommended that the suction tubes are a larger diameter than the discharge tubes. If a larger
diameter tube needs to be installed above the suction intake an eccentric reducer bushing must be
installed.
If installing suction with load (fig.1), it is essential to install a valve (b) between the tank and the pump
for subsequent handling.
Bominox, S.A. - Installation and Maintenance Instructions
-25 - +130 ºC (with special assembly)
16 bar
2900 rpm (50 Hz)
3450 rpm (60 Hz)
500 cP
Parts in contact with product: AISI 316 (EN 1.4401)
Other metal parts: AISI 304 (EN 1.4301)
Joints: EPDM
Mechanical seal: Carbon/SiC (standard), SiC/SiC
Type: IEC B14 or B5 (depending on assembly)
Protection: IP55 | Class F
Power: 0.37 - 22 kW (0.5 - 30 hp)
Voltage: 220-240V ∆ / 380-420V Υ (≤ 4 kW)
380-420V ∆ / 660-690V Υ (≥ 5.5 kW)
EN 9

Publicidad

Tabla de contenido
loading

Productos relacionados para Bominox LACTIC Serie

Este manual también es adecuado para:

L-0L-11L-12L-21L-22L-31 ... Mostrar todo

Tabla de contenido