Infrared Remote Control; Operation - Chauvet DJ KINTA FX ILS Manual De Instrucciones

Operation

IRC-6 Infrared Remote Control
The Kinta FX ILS can be operated with the CHAUVET IRC-6. To enable IR wireless control, follow the
instructions below.
1. Press <MENU> repeatedly until SEt shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select from on or oFF.
4. Press <ENTER>.
IRC-6 Operation
Automatic Mode
To turn on automatic mode with the IRC-6:
BLACK
AUTO SOUND
OUT
To adjust the speed of the automatic program:
SENSI-
STROBE SPEED
TIVITY
%
MANUAL FADE
Sound-Active Mode
R G B
To turn on sound-active mode with the IRC-6:
A UV W
Manual Control
-
+
0
To manually select the kinta effect color with the IRC-6:
1 2 3
4 5 6
Strobe
7 8 9
To set the strobe with the IRC-6:
Black Out
To black out the product with the IRC-6:
This will turn off all the LEDs until the button is pressed again.
NOTE: The IRC-6 will not respond to any inputs when Black Out is activated. If the
product does not respond when a button is pressed, try pressing <BLACK OUT>.
Black Out may have been activated.
The buttons on the IRC-6 not listed above are reserved for future use.
Kinta FX ILS User Manual Rev. 5
1. Press <AUTO> on the IRC-6.
2. Press <1>–<7> to select the program (see
1. Press <SPEED> on the IRC-6.
2. Press <+> or <–> to increase or decrease the speed.
1. Press <SOUND> on the IRC-6.
2. Press <1>–<7> to select the program (see
1. Press the desired color, from <R> (red), <G> (green), <B> (blue), or
<W> (white).
1. Press <STROBE> on the IRC-6.
2. Press <+> or <–> to increase or decrease the strobe speed.
1. Press <BLACK OUT> on the IRC-6.
Colors and Programs).
Colors and Programs).
Page 16 of 117