Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
7.2
Flame Adjustment
1.
Slide the adjustment lever [8] to the right to increase the flame.
2.
Slide the adjustment lever [8] to the left to decrease the flame.
Note:
Longer flames may cause the torch to flare or shut off. Please decrease the flame until the flame
reaches a blue glow.
7.3
Shut-Off
1.
Slide the flame switch [7] to the far left.
2.
Let the soldering iron cool down.
7.4
Other Functions
Torch
1.
Rotate the nut in an anticlockwise direction and remove the soldering tip [5], the head [4] and the
metal sleeve [6].
2.
Disassemble the soldering tip [5], the head [4] and the metal sleeve [6] assembly.
3.
Re-install the metal sleeve [6] and secure with the nut.
4.
The soldering iron can now be used as a torch. Operate the soldering iron as described under
7. Operation.
Hot Blower
1.
Remove the soldering tip [5] by rotating it in an anticlockwise direction.
2.
The soldering iron can now be used as a hot blower. Operate the soldering iron as described under
7. Operation.
8.
Troubleshooting
problem
The soldering iron does not
ignite
Excessive gas flow
Low gas pressure
9.
Technical Specifications
autonomy
gas container capacity
temperature
soldering temperature
hot blow temperature
torch temperature
dimensions
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulting from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual, please visit our website
www.velleman.eu. The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part
of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
V. 01 – 24/11/2014
GAS/SET2
probable cause
Empty fuel
Gas pressure too high/low
Setting is too high
Low fuel
Cold fuel
90 min. (average use)
15 ml
up to 500° C
up to 600° C
up to 1300° C
Ø 29 x 245 mm
5
possible solution
Refuel
Slide the adjustment lever to
the left/right
Adjust the flame gradually
Refuel
Hold in your hands to warm up
©Velleman nv
Publicidad
Tabla de contenido
