Memory - Medisana MTX Instrucciones De Manejo

5.1
Recording
the results
5.2
Displaying
stored results
5.3
Deleting a
measurement
5.4
Deleting

memory

This unit features 2 separate memories, each with a capacity of 99 memory
slots. Results are automatically stored in the memory selected by the user.
When the memory is full, the oldest reading is always the first to be deleted.
Press the MEMORY button
ments in the display have been shown, an average value of all the measure-
ments in the selected memory is displayed. This average is indicated by "
When the MEMORY button
(switching between systolic, diastolic, pulse and date/time) of the last mea-
surement stored are displayed. If this measurement was taken in the 3MAM
procedure, is displayed. If an arrhythmia was detected during
the measuring process, the arrhythmia symbol
flashing.
Press the MEMORY button
readings.
If you do not press any buttons for approx. 1 minute, the device automatically
switches back to standby mode.
Select the entry for the measurement you want to delete. Press and hold
the START button
flashes. Confirm your deletion request by pressing the MEMO button
" " appears briefly on the display and 2 short beeps sound. The entry
you selected has been deleted. The display returns to standby mode.
The data can be deleted from the memory selected by pressing and holding the
MEMORY button for about 7 seconds. After 7 seconds, the display
shows " " ( CLEAR ) which indicates that all data will be deleted.
Confirm your deletion request by pressing the MEMO button
short beeps sound during the procedure.
to display the stored readings. After all the seg-
is pressed again, the individual readings
again to move backwards through the stored
for approx. 10 seconds until the memory symbol
5 Memory
will be displayed, but not
again. Three
31
GB
".
.