Publicidad
Idiomas disponibles
Idiomas disponibles
2) All electrical fittings (power outlets, switches, etc) must be at least 60 cm from the bath or at a height of
225 cm.
3) The power supply line must be suitable for the power requirement of the bath (see technical specifications,
page 17).
4) The point where the bath is connected to the electrical system must be suitably protected against
splashing water (degree of protection IP55 or greater).
5) The whirlpool system must be fitted with a 30 mA switched circuit breaker with a minimum contact
opening of 3 mm.
6) The bath frame has an earth terminal that must be properly connected to the earthing system of the
supply circuit,
7) The whirlpool baths is provided with electrical connection of the type Y, if the power cord is damaged, it
must be replaced by the manufacturer or by its technical assistance service or in any case a person with
similar qualification, so as to prevent any risk.
(refer to illustrations on page 27).
equipotentiality
-5-
ENGLISH
Publicidad
