Features; Assembly - RIDGID R82009 Manual Del Operador

FEATURES

PRODUCT SPECIFICATIONS
Chuck ...........................................................3/8 in. Keyless
Motor .................................................................. 12 Volt DC
Switch .............................. VSR (Variable Speed/Reversible)
KNOW YOUR DRILL
See Figure 1, page 12.
The safe use of this product requires an understanding of
the information on the product and in this operator's manual
as well as a knowledge of the project you are attempting.
Before use of this product, familiarize yourself with all op-
erating features and safety rules.
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE/CENTER LOCK)
Your drill has a direction of rotation (forward/reverse/center
lock) selector located above the switch trigger for changing
the direction of bit rotation. Setting the direction of rotation
selector in the OFF (center lock) position will lock the switch
trigger to help reduce the possibility of accidental starting
when not in use.
KEYLESS CHUCK
The keyless chuck allows you to hand-tighten or release the
drill bit in the chuck jaws.

ASSEMBLY

UNPACKING
This product has been shipped completely assembled.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Do not use this product if it is not completely
assembled or if any parts appear to be missing
or damaged. Use of a product that is not properly
and completely assembled could result in serious
personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
PACKING LIST
Drill
Bit
Operator's Manual
No Load Speed ...................... 0-350 / 0-1500 r/min. (RPM)
Clutch ................................................................ 18 Position
Torque ................................................................... 300 in.lb.
LED LIGHT
The LED light, located under the chuck, illuminates when
the switch trigger is depressed. This provides extra light for
increased visibility.
LOW BATTERY INDICATOR
If the LED light flashes during operation, this indicates a low
battery charge condition and signals that the battery should
be recharged soon.
TORQUE ADJUSTMENT RING
Your drill has an 18-position clutch. The torque adjustment
ring can be turned to select the right amount of torque for
your application.
TWO-SPEED GEAR TRAIN
The two-speed gear train is designed for drilling or driving
at LO (1) or HI (2) speeds. A slide switch is located on top
of your drill for selecting either LO (1) or HI (2) speed.
VARIABLE SPEED
The variable speed switch trigger delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause
serious personal injury, always remove the battery
pack from the product when assembling parts.
6 - English