Hilti SR 4-A22 Manual De Instrucciones Original página 12

Battery charge state cannot be indicated while the control switch is pressed and for 5 seconds after
the control switch has been released. If the LEDs of the charge state indicator flash, follow the
instructions in the 'Troubleshooting' section.
3.5 Items supplied
Reciprocating saw, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group | USA: www.hilti.com
4 Technical data
4.1 Reciprocating saw
Rated voltage
Weight including battery B22⁄8.0
Stroke rate
Stroke length
Keyless chuck for standard accessory tools
4.2 Battery
Battery operating voltage
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
5 Operation
5.1 Safe operation 2
CAUTION
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
WARNING
Risk of injury! Risk of kickback.
▶ Always use saw blades of adequate length. The end of the saw blade must always project beyond the
workpiece over the entire blade stroke.
WARNING
Risk of injury! Caused by the chuck / accessory tool retaining mechanism
▶ Always hold the power tool securely with both hands on the grips provided. Never use the power tool
without a fully functional hand guard.
The power tool must be pressed against the workpiece until the AVR contact shoe makes firm
contact. This ensures optimum and safe progress as you work.
▶ Pull the battery back and out of the product.
5.2 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
6 English
SR 4-A22
21.6 V
4.4 kg
0 /min ... 3,000 /min
28 mm
1/2 in
21.6 V
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
−10 ℃ ... 45 ℃
2200412
*2200412*