General Introduction; Introduction; Intended Use; General Safety Measures - Ravaglioli G7645.XX Manual De Instrucciones

This manual is an integral part of the product and must be retained for the whole operating life of the
machine. Keep the manual in a known, easily accessible place for all operators to consult it whenever in
doubt. The manufacturer disclaims all responsibility for any damage due to non-compliance with the
indications given in this manual.
0.

GENERAL INTRODUCTION

0.1

Introduction

Thank you for preferring RAVAGLIOLI electro-hydraulic tyre-changer. We feel sure you will not regret your decision.
This machine has been designed for use in professional workshops and stands out for its reliability and easy, safe
and rapid operation. With just a small degree of maintenance and care, this tyre-changer will give you many years
of trouble-free service and lots of satisfaction.
This manual contains all operating instructions and details on how to service and use the machine correctly.
0.2

Intended use

G7645 series tyre-changers are designed to remove and fit car and other vehicle tyres with the technical
specifications given in Chapter 9 - Technical Specifications table.
DANGER: THIS MACHINE MUST BE USED STRICTLY FOR THE INTENDED PURPOSE IT WAS
DESIGNED FOR (AS INDICATED IN THIS MANUAL). ANY OTHER USE WILL BE CONSIDERED
IMPROPER USE.
In particular TYRE INFLATING AND BEADING:
• MUST BE CARRIED OUT WITH CAUTION AND CARE (SEE PARAGRAPHE "TYRE
INFLATING"), RESPECTING PRESSURE LIMITS INDICATED BY TYRE MANUFACTURERS;
• CAN BE CARRIED OUT ONLY ON MACHINES EQUIPPED WITH SUITABLE INFLATING
UNITS ("I" - "IT" MODELS OR MODELS FITTED WITH PROPER OPTIONAL ACCESSORIES).
INFLATING UNITS ARE EQUIPPED WITH A PRESSURE LIMITING DEVICE: IF PRESSURE
NEEDED FOR TYRE BEADING AND INFLATING IS HIGHER THAN LIMITING DEVICE MAX.
PRESSURE, THESE OPERATIONS MUST BE CARRIED OUT IN A SPECIALLY APPROVED
INFLATION CAGE.
• IT IS RECOMMENDED NOT TO USE THE EQUIPMENT FOR INTENSIVE USE IN INDUSTRIAL
ENVIRONMENT.
0.3

General safety measures

A. WHEN OPERATING AND SERVICING THIS MACHINE, CAREFULLY FOLLOW ALL APPLICABLE
SAFETY AND ACCIDENT-PREVENTION PRECAUTIONS.
B. THE MACHINE MUST NOT BE OPERATED BY PROFESSIONALLY UNSKILLED PERSONS.
C. IT IS FORBIDDEN TO MAKE CHANGES TO THE MACHINE OR ITS COMPONENTS WITHOUT THE
PRIOR APPROVAL OF THE MANUFACTURER.
D. USE ORIGINAL ACCESSORIES AND SPARE PARTS ONLY. HAVE THEM INSTALLED BY SKILLED
PERSONNEL FOLLOWING THE INSTRUCTIONS GIVEN IN THIS MANUAL. THE MANUFACTURER
SHALL NOT BE RESPONSIBLE FOR INJURY OR DAMAGE ARISING FROM UNAUTHORISED
CHANGES MADE TO THE MACHINE OR FAILURE TO USE ORIGINAL ACCESSORIES AND
COMPONENTS.
E. THE REMOVAL OR MODIFICATION OF THE SAFETY DEVICES OR WARNING SIGNS ON THE
MACHINE CAN CAUSE SERIOUS DAMAGE AND REPRESENTS AN INFRINGEMENT OF EUROPEAN
SAFETY REGULATIONS.
F. THE MACHINE IS SUITABLE FOR OPERATION IN PREMISES WHERE THERE IS NO RISK OF
EXPLOSION OR FIRE.
G. MAKE SURE NO HAZARDOUS SITUATIONS OCCUR DURING OPERATION. WHEN THIS IS THE CASE,
IMMEDIATELY STOP THE MACHINE.
H. IN EMERGENCY SITUATIONS AND BEFORE CARRYING OUT ANY MAINTENANCE OR REPAIRS,
DISCONNECT ALL SUPPLIES TO THE MACHINE, I.E. UNPLUG THE POWER PLUG AND DISCONNECT
THE COMPRESSED AIR SUPPLY TUBE. IN THE EVENT OF FAULTY OPERATION, STOP THE
MACHINE AND CONTACT THE DEALER'S CUSTOMER SERVICE.
THE WORKSHOP ELECTRICAL SYSTEM MUST BE PROPERLY EARTHED. THE YELLOW-GREEN
EARTH LEAD OF THE MACHINE MUST BE CONNECTED TO THE SHOP EARTH WIRE.
30
7300-M009-0_R