Publicidad
• Place two spike disks (7), separated by a long spacer
tube (20), onto the shaft. Fit the long spacer tube onto the
ends of the flanged bearings in the disks. See figure 19.
20
FIGURE 19
• Place two 5/8" flat washers (33) separated by a long
spacer tube (20) onto the shaft. See figure 20.
20
33
FIGURE 20
• Place a spike disk (7) and a short spacer tube (41)
onto the shaft. Fit the short spacer tube onto the ends
of the flanged bearings in the spike disk and in the end
plate. Push the shaft on through the flanged bearing in the
end plate. See figure 21.
41
FIGURE 21
7
7
• Place one or two 5/8" flat washers (33) onto the end
of the spike disk shaft and secure the shaft with a 1/8" x
1-1/2" cotter pin (23) by spreading the ends of the cotter
pin. See figure 22.
• Fasten the two drive disks to the shaft using two 1/8" x
1-1/2" cotter pins (23) by spreading the ends of the cotter
pin. See figure 22.
33
FIGURE 22
• Remove connecting link from chain and assemble the
chain (47) onto the two sprockets on the left side of the
hopper. Fasten the ends of the chain together using the
connecting link. See figure 23.
• Place the chain cover over the chain and fasten it to
the hopper end plate using two self tapping screws (31).
See figure 23.
47
CONNECTING
LINK
FIGURE 23
11
23
23
8
31
Publicidad
