Publicidad
• Screw a 1/4" nylock hex nut (26) all the way onto the
flow control link (44). Assemble the ferrule (49) onto the
link and then start a 1/4" nylock hex nut one or two turns
onto the link. See figure 7.
• Assemble the ferrule (49) into the hole at the end of
the flow control lever (2) using a 1/4" nylock hex nut (26).
Tighten the nut, leaving it loose enough that the ferrule
can pivot. See figure 7.
• Assemble the grip (43) onto the end of the flow control
lever. See figure 7.
43
2
26
49
44
FIGURE 7
26
26
• Place the flow control lever into the slot in the hopper.
See figure 8.
• Place the center brace (3) into the hopper. Insert the
1/4" x 1-1/4" hex bolt (19) through the center brace and
the front of the hopper. Assemble a 1/4" flat washer (37),
the flow control lever and a 1/4" nylock hex nut (26) onto
the bolt. Do not tighten yet. See figure 8.
• Insert the 1/4" x 3/4" hex bolt (30) through the center
brace and the rear of the hopper. Assemble a 1/4" flat
washer (37) and 1/4" nylock hex nut (26) onto the bolt.
Tighten both the front and rear bolts. See figure 8.
3
37
26
FIGURE 8
• Insert the 5/16" x 1-3/4" carriage bolt (18) up through
the slot and secure it with a nylon washer (36) and the
plastic wing nut (39). See figure 9.
• Move the lift handle into the locked position as shown
in figure 9 and then tip the spreader back to rest on the
wheels and the rear of the hopper.
FIGURE 9
8
19
30
37
26
39
36
18
Publicidad
