Fein WSG8-115 Manual De Uso página 25

OBJ_BUCH-0000000224-002.book Page 25 Tuesday, February 23, 2016 10:09 AM
Working instructions.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
For each job, use only the FEIN application tool released and intended for the respective
application.
Switching on and off.
Check the power supply cable
WARNING
and the plug for damage.
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
The self-start lock prevents the angle grinder
(see Table) from automatically restarting
again, even after a brief interruption of the
power supply, e. g., from a pulled power plug.
WSG8-115 (**)/WSG8-125 (**)/WSG11-125 (**)/WSG11-150 (**)/WSG12-125P (**)/
WSG17-125P (**)/WSG17-125PS (**)/ WSG17-150P (**)/WSG17-70 Inox (**) (figure 9).
Switching on:
Push the On/Off switch forward (I).
Switching off:
Push the On/Off switch back ().
Angle grinders with electronics (see Table)
are equipped with overload and blocking pro-
tection. In case of overload or blocking of the
application tool, the power supply is inter-
rupted. in this case, switch the power tool off,
remove it from the workpiece and check the
application tool. Afterwards, switch the
power tool on again.
WSG12-125P (**) WSG17-125PRT (**)
WSG17-125P (**) WSG17-150PR (**)
WSG17-125PS (**) WSG17-150PRT (**)
WSG17-150P (**) WSG17-70 InoxR (**)
WSG17-70 Inox (**) WSG17-70 InoxRT (**)
WSG17-125PR (**)
Fig. 9
On/Off switch
en
25