Operation With The Remote Control; Up And Down Buttons - Danby DAS090BAHWDB Manual Del Propietário

OPERATING INSTRUCTIONS

OPERATION WITH THE REMOTE CONTROL

• The air conditioner will not operate if curtains, doors or other materials block the signal from the remote
control to the indoor appliance.
• Do not expose the remote control to water, direct sunlight or excessive heat.
• Do not allow direct sunlight to fall on the infrared receiver on the indoor appliance as this can impede
the signal from the remote control.
• Remote signal reception is confi rmed with a beep.
ON/OFF: Turns the appliance
on or off
MODE: Selects mode
operation in the following
order:
Auto --> Cool --> Dry --> Heat
--> Fan
FAN: Selects fan speed in the
following order:
Auto --> Low --> Med --> High
SLEEP: Conserves energy
during sleeping hours
TURBO: Starts and stops the
turbo function, which will run
the appliance continuously to
reach the preset temperature
in the shortest amount of time;
after running for 30 minutes
turbo mode will stop
Symbol will fl ash
to indicate that the
appliance has received
the signal from the
remote control.
LED: Turns the LED
display on or off
Remote Control Specifi cations
Model
Rated Voltage
Signal Receiving Range
Environment
4

UP AND DOWN BUTTONS:

Used to increase or decrease
the temperature setting in 1°
increments. Press and hold
the up and down buttons for
three seconds to change the
temperature scale between
°C and °F
SHORTCUT: Used to restore
the current settings or resume
previous settings
TIMER ON: Used to set
automatic on function
TIMER OFF: Used to set
automatic off function
DIRECT: Used to change the
louver movement and set the up
or down air fl ow direction
SWING: Used to start or
stop the horizontal louver
swing feature
RG57B/BGEU1
3.0V (dry batteries R03/LR03x2)
8m (26 feet)
-5°C to 60°C (23°F to 140°F)