Caster Installation - Danby DDR050EBPWDB Manual Del Propietário

OPERATING INSTRUCTIONS

CASTER INSTALLATION

The casters and power cord can be found inside the
water bucket.
1. Remove the bucket from the appliance and
remove the bucket cover.
2. Remove the casters and power cord from the
water bucket.
3. Replace the bucket cover and replace the bucket
inside the appliance.
4. Tilt the appliance to a 45° angle. Push the
casters into the bottom of the appliance until
they click. Ensure the ring around the caster is
fl ush against the bottom of the appliance.
1
2
3
4
OPERATION
• Place the dehumidifi er on a smooth, level fl oor
that is strong enough to support the appliance
with a full bucket of water.
• Do not place the dehumidifi er on carpeting as
this can block air fl ow around the appliance.
• Do not force casters to move over carpeting as
the appliance can become unbalanced and spill
water.
• To maintain effi ciency, operate the appliance
in an enclosed area. Keep nearby doors and
windows closed.
• Any time the appliance is placed on its back or
side, it must be allowed to stand upright for 6
hours before plugging in to avoid damage to
internal components.
• Maintain a minimum clearance of 45 cm (18
inches) on all sides of the appliance to allow for
proper air circulation.
• The recommended ambient operating
temperature is between 5°C (41°F) and 32°C
(90°F).
• The recommended ambient operating humidity
is between 30 - 90%.
• The default humidity setting is 50% and low fan
speed. Depending on humidity conditions the
dehumidifi er may not start automatically under
the default setting. This means the humidity in
the surrounding air is less than 50%. Press the
down button to lower the set humidity until the
set humidity is lower than the ambient humidity.
• For optimal performance, ensure that the
humidity setting is 10% lower than the ambient
humidity. It is normal for the ambient humidity to
vary up to 5% above or below the set humidity.
• It is recommended in normal conditions to set
the humidity between 40-45%.
• It is normal for the dehumidifi er to exhaust warm
air from the top.
3