Step 3 - Align Door - Haier HC46SF10SV Manual Del Usuario

INSTALLATION REQUIREMENTS
STEP 2 - DOOR REVERSING
9. Remove the screw from the side where you want to install the bottom
hinge (left-hand side).
10. Insert the hinge pin into the hole in the bottom edge of the door. Align
the holes in the hinge plate with the holes in the cabinet bottom. Using the
screw just removed and the two remaining screws from the opposite side,
fasten the hinge to the cabinet.
11. Stand the refrigerator upright.
12. Align the top hinge plate with the hinge holes, insert screws and partially
tighten. Make sure that door and cabinet are properly aligned and then
tighten the top hinge screws completely.
13. Replace the top hinge cover by first aligning the back of the cover with
the back of the hinge, and then pressing down firmly on the front of the
hinge cover until it snaps into place.
STEP 3 - ALIGN DOOR (If necessary)
1. Using a flat-blade screwdriver, gently insert the blade under the top hinge
cover and pry up to remove.
2. Using a Phillips-head screwdriver, loosen the three top hinge screws.
3. Adjust the door or put a spacer between the hinge and cabinet, and then
tighten the screws.
4. Replace the top hinge cover by first aligning the back of the cover with the
back of the hinge, and then pressing down firmly on the front of the hinge
cover until it is fully seated.
12
(Optional) (Cont.)
49-60797