Attach The Guard; Attach The Edge Guide; Assemble The Shaft; Attach The Auxiliary Handle - GreenWorks Pro ST60B01 Manual Del Operador

WARNING
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
8.2

ATTACH THE GUARD

WARNING
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a Phillips
head screwdriver (not included).
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw holes
on the trimmer head.
4. Tighten the screws.
8.3

ATTACH THE EDGE GUIDE

The edge guide can limit the cutting range of the machine
and decrease the risk of the damage caused by the rotating
cutting line.
1. Push the edge guide onto the trimmer head until it
engages in the slots.
NOTE
English
2. The edge guide can be flipped up for storage.
8.4

ASSEMBLE THE SHAFT

1. Loosen the knob (13) on the coupler (8).
2. Push in the release button (14) on the lower shaft (9).
3. Align the release button with the positioning hole (15)
and move the two shafts.
4. Turn the lower shaft until the button locks into the
positioning hole.
5. Tighten the knob.
15
15
9
14
8.5 ATTACH THE AUXILIARY
HANDLE
1. Remove the screws from the handle with a Phillips
screwdriver (not provided).
2. Attach the auxiliary handle (6) and lower clamp (16) on
the shaft.
3. Set the auxiliary handle in the comfortable position.
4. Tighten the screws.
7
EN
8
13