Install The Battery Pack; Remove The Battery Pack; Operation; Controls - GreenWorks Pro ST60B01 Manual Del Operador

EN
6
8.6

INSTALL THE BATTERY PACK

• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read and understand the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
1
8.7

REMOVE THE BATTERY PACK

1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
9

OPERATION

Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
9.1

CONTROLS

9.2

START THE MACHINE

16
WARNING
IMPORTANT
WARNING
English
1. Push the lock-out lever (3) and pull the trigger (4).
2. Push the speed switch (5) to the desired operating speed.
Push the speed switch to position 1 for low speed or
position 2 for high speed.
9.3

STOP THE MACHINE

1. Release the trigger to stop the machine.
9.4 ADJUST THE LENGTH OF THE
CUTTING LINE
While you operate the machine, the cutting line gets worn and
shorter. You can adjust the length of the cutting line.
1. Hit the trimmer head against the ground while you
operate the machine.
2. Line is automatically released and the cut-off blade cuts
the excess length.
9.5

LINE CUT-OFF BLADE

This trimmer is equipped with a line cut-off blade on the
guard. The line cut off blade continuously trims the line to
ensure a consistent and efficient cut diameter. Advance line
whenever you hear the engine running faster than normal, or
when trimming efficiency diminishes. This will maintain best
performance and keep line long enough to advance properly.
8
3
5
4