Safety Instructions - ProMed HKP-1.2 Instrucciones De Empleo

CARE INSTRUCTIONS
• The heating pad and its cover cannot be tumble dried.
• Do no use any high-pressure cleaners.
• Make sure that the controller does not come into contact with any liquids. Liquids may result in damage.
• Never use the heating pad while it is wet or damp. The heating pad must not be switched on while it is
drying.
• Let the heating pad air dry. Do not use any auxiliary means (such as clothes pegs) to hang it up to dry. This
may damage the cables inside.
Storage and regular inspection
• Do not crumple the heating pad. Carefully fold the product to store it.
• Store the device in a dry place when it is not in use.
• Allow the device to cool before you fold or roll it up.
• Inspect the device and the power cable for possible signs of wear or damage at regular intervals.
• If there are such signs, if the appliance has been misused or does not work, return it ro the supplier before
switching it on again.
• Please do not use any chemical moth protection.
• Do not place any heavy objects on the device during storage, as this may damage the electrical wiring.
• In the event of malfunction or defects, send the device to the manufacturer.
DE

SAFETY INSTRUCTIONS

EN Please note the following aspects prior to any commissioning:
A. The heating pad may only be used with the controller supplied.
B. Voltage supply of the heating pad: 220 - 240V~.
C. If any problems occur with the heating pad, please send it to the manufacturer.
FR
D. Only for indoor use.
E. When using an electrical device near children, conscientious
supervision is required.
IT
DANGER!
• Never bring the device into direct contact with water or other liquids.
ES
• Never use the device in the bathtub, shower, pools, saunas or outdoors.
• Do not touch the device with wet hands.
• Only operate the device with the supply voltage specified.
NL
• The device must not be used outdoors.
• This device uses supply voltage; therefore, the same safety regulations as for any other electrical device
apply.
RU
• Prior to any commissioning of the device, check that all components of the device are in perfect condition.
In the event of a defect or a malfunction, immediately switch off the device and disconnect the power plug
from power supply system.
• Any repair work may only be carried out by the manufacturer. Never open the device. The individual
PL
components of this device must not be disassembled, repaired or modified.
• Only use the device in dry rooms and if your body is dry.
• Never operate the device next to other sources of heat.
SE
• Never carry or pull the device by holding it on the power cable. Disconnect the cable from the power socket
using the plug and never using the cable.
• Do not pull the power cable over sharp edges or pinch it, do not let it hang down and do not place or
suspended it over hot objects (e.g. hobs) or open flames and protect it against heat or oil.
FI
• Only use an extension cable if you previously made sure that it is in a perfect condition.
• If the power cable of the device is damaged, have it immediately replaced by an expert.