Commissioning The Device; Troubleshooting; Care Instructions - ProMed HKP-1.2 Instrucciones De Empleo

COMMISSIONING THE DEVICE

Before getting started, please check that the delivery is complete.
Make sure that the heating pad does not get stuck.
Please use original parts only!
Please do not use any other controller!
Attention
Please ensure that the heating pad is not too tight so that some air can circulate between the heating
pad and your skin when using it.
Under all circumstances, avoid accumulation of heat.
1. Check if the two plugs (plug of the controller (E) and plug of the heating pad (F)) are connected to each
other. If they are not, connect them to each other. Otherwise, please ensure that they are correctly connected
to each other. To operate the heating pad, insert the power plug (A) into the power socket.
2. In order to set the desired temperature, slide the temperature control (D) to the desired level (0 = OFF,
1 = low temperature, 2 = medium temperature 3 = maximum temperature). On the display screen (C),
the set level is now shown.
3. The heating pad switches off automatically after approx. 90 minutes.
4. In order to restart the heating pad after the operating time has expired, you must set the temperature control
(D) to "0". After 10 seconds, you can start it by setting the temperature again.
5. After use, please disconnect the power plug from the power socket.
6. Move the selector switch to position 1 or 2 before falling asleep or any continuous use.

TROUBLESHOOTING

Problem
The device is not connected to
the power supply system
The device does not
The device is not switched on
warm up.
The device is defective

CARE INSTRUCTIONS

• Before cleaning the heating pad, the power plug must be disconnected from the power socket.
• In order to clean the heating pad, open the snap buttons on its cover and pull out the heating pad.
• The heating pad and its cover can be washed by hand or in the washing machine at 40°C using a
mild detergent.
• Do not iron the heating pad.
• Please do not use any detergents containing chlorine.
• Do not dry clean the heating pad.
Cause
Insert the power plug into the power
socket and switch on the device
Switch on the device
Send the device to the manufacturer
Troubleshooting
DE
EN
FR
IT
ES
NL
RU
PL
SE
FI