Guide Rail - Makita XSH10 Manual De Instrucciones

► 1 . Retracting lever
Sub base (Guide rule)
CAUTION:
Make sure that the sub base (guide
rule) is securely installed in the correct position
before use. Improper attachment may cause danger-
ous kickback.
By using the sub base as a guide rule, you can perform
extra-accurate straight cuts. Loosen the clamping
screws and slide the sub base out from the tool then
insert it upside down.
1
► 1 . Clamping screw 2. Sub base
Simply slide the fence of the sub base snugly against
the side of the workpiece and secure it in position with
the clamping screws. It also makes repeated cuts of
uniform width possible.
1
► 1 . Clamping screw 2. Sub base

Guide rail

Optional accessory
NOTICE:
guide rail.
Place the tool on the rear end of guide rail. Turn two
adjusting screws on the tool base so that the tool slides
smoothly without a clatter. Hold both the front grip and
rear handle of the tool firmly. Turn on the tool and cut
the splinter-guard along the full length with a stroke.
1
Now the edge of the splinter-guard corresponds to the
cutting edge.
2
► 1 . Adjusting screws
15 ENGLISH
1
Remove the sub base when using the
1
2
1