Metra 99-6519 Instrucciones De Instalación página 2

Dash Disassembly
1. Unclip and remove entire panel
surrounding radio and climate
controls, including A/C vents.
(Figure A)
2. Remove (4) 7 mm screws securing
radio to dash and remove radio.
(Figure B)
3. Remove factory vents and climate
controls from the factory radio
panel and transfer to the 6519B
radio panel using the factory
screws. (Screws are also provided
in this package).
Continue to kit assembly
(Figure B)
(Figure A)
99-6519
DIN radio provision with pocket
1. Slide the DIN cage into the radio
housing and secure by bending
the metal locking tabs down.
(Figure A)
2. Slide the aftermarket radio into the
cage until secure. (Figure B)
3. Snap the pocket into the radio
housing. (Figure C)
4. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
5. Reassemble dash in reverse order
of disassembly, using the new
Metra radio housing trim panel.
2
Kit Assembly
(Figure A)
(Figure B)
(Figure C)