Andis BGRC Manual Del Usario página 4

3. Before initial use battery pack must be charged for a minimum
of one hour.
4. The charger base has two indicator lights: Below is a
description of the Sensacharge light sequences (Diagram C):
Continuous Green Light (Fast Charge) - Charger will fully
charge battery pack in less than one hour.
Rapid Green Blinking Light (Charging Complete) - Battery
pack is fully charged.
Long Green Blinking Light ("Refresh") - Charger is draining
battery pack in preparation for fast charge. Please reference
the section "Use of the Refresh Feature" on page 6 for an
explanation.
Short Green Blinking Light -
a) with Continuous Red Light (Charge Standby) -
Battery pack is trickle charging because it is either too
hot or too cold to accept a fast charge. Fast charging
will occur once battery pack temperature moderates.
b) without Red Light (Charge Preparation) - Battery
pack is undergoing trickle charge, because it has
been drained excessively during use.
5. The clipper can be left in the charger base for an indefinite
period of time. The charger will supply only what is needed and
will not damage the battery due to overcharge.
SAFETY RULES FOR ChARGER AND BATTERY pACK
1. Clipper motor switch must be in the "OFF" position for the
charger to operate properly. Do not return the clipper to the
charger base with the motor switch in the "ON" position.
If the clipper is accidentally put on the charger base in the
"ON" position, remove it promptly. Turn clipper off and return
to the charger base.
2. Do not insert anything metallic into the battery pocket of the
charger base (Diagram D).
3. Do not allow the ventilation slots on the charger base to
become blocked or filled with foreign material. Avoid subjecting the charger to excessively dirty
locations. If the slots become clogged with dust or hair, unplug charger and gently remove hair
with a soft brush or a vacuum cleaner.
4. Do not attempt to charge any other battery other than the battery pack designed for your Andis Clipper.
5. The battery pack contains an overload protection feature. Do not attempt to use it to power any
other product other than the Andis Cordless Clipper. Do not touch the exposed metal contacts on
the battery pack with any conductive material.
6. Do not store battery or charger where it is under 50°F or over 104°F, as damage may occur.
7. Do not expose the charger base or the battery pack to excessively damp conditions.
8. Avoid dropping the charger base and the battery pack. Do not attempt to use a damaged battery
pack or charger.
9. Clean external parts of charger with a soft brush or damp rag. Do not use harsh abrasives,
detergents, or solvents.
4
Diagram B
Diagram C
Diagram D