Battery Use - Andis BGRC Manual Del Usario

wARNiNG: Upon removal, cover the battery pack's terminals with heavy duty adhesive
tape. Do not attempt to destroy or disassemble battery pack or remove any of its
components. Nickel-cadmium batteries must be recycled or disposed of properly. Also,
never touch both terminals with metal objects and/or body parts as short circuit may
result. Keep away from children. Failure to comply with these warnings could result in
fire and/or serious injury.
SAVE ThESE iNSTRUCTiONS
ThiS pRODUCT iS iNTENDED FOR COMMERCiAL USE
Cord pack Use
1. Models BGRC/BGR+ will run on an average of 3800 SPM with the
cord pack attached.
2. Models BGRC/BGRV/BGR+ can be used with either the cord pack or
the battery.
3. Models BGRV/BGR+ with cord pack have 5 speed settings ranging
from 1900 SPM to 3800 SPM.
4. Remove the transformer wall plug and clipper from the carton.
5. With the clipper in the off position, insert the adapter plug into the
bottom of the clipper. Note that the adapter plug is fitted with a
tongue to align properly with the groove in the clipper. Once the
adapter plug and clipper are aligned, press firmly together. You may
hear a click as the adapter plug contacts engage.
6. Plug the transformer wall plug into the AC outlet as identified on the
carton.
7. The clipper is now ready to be used.

Battery Use

1. Models BGRC/BGRV/BGR+ will run on an average of 3800 SPM with the battery pack attached.
2. Models BGRC/BGRV/BGR+ can be used with either the cord pack or the battery.
READ ThE FOLLOwiNG BEFORE ChARGiNG ThiS CLippER
1. Remove the charger from the carton and plug into an AC outlet as identified on charger unit and
on carton.
2. Place the Andis Model BGR+ Cordless Clipper in the form fitting
pocket in the charger base (Diagram A). Note that the battery pack is
fitted with a slot to align properly with the charger. Once the battery
and charger are aligned, press the battery pack firmly into the
charger until it rests at the bottom of the pocket. You may hear a
click as the charging contacts engage this is normal. The battery
pack may be charged while on the clipper, or separately. Push the
battery release button (Diagram B) on the clipper, and pull straight
out to remove the battery. NOTE: The battery pack is designed to run
the clipper for about one hour. A clean, sharp, well-oiled blade will
provide the best run time.
Tongue
Adapter
Plug
Transformer
Wall Plug
Diagram A
3