GIESSE TUBE-LOCK Manual De Uso E Instalación página 27

▪
Once the outline has been marked, mill the window frame with a minimum depth of 24 mm; a Ø4 mm
milling cutter is recommended. Use a drill bit with a diameter corresponding to the selected clamping
screws to drill holes in the two points marked for fastening the device.
▪
Clean the edges with a shaver or using a fine-grit file to eliminate any burr that could obstruct or ruin
the cables during assembly of the devices.
▪
Check - by overlapping them - that the electromechanical lock is positioned correctly and the hook (in
the closed position) is aligned with the pawl of the closed sliding accessory.
▪
Check that the electrical cable path is free of obstacles, otherwise eliminate them.
▪
Now the window frame can be assembled.
8.2.3.
Recessed assembly
•
Assemble the actuator in the recessed hole made previously on the window frame, taking care not to
damage the cable.
•
Fix the screws that secure the actuator.
•
Make the electrical connections following the instructions and diagram provided below in Chapter 9.
"Electrical connection".
•
Complete the path of the cables and finish making the electrical connections.
The device requires a voltage of 24V ═ (DC). Higher voltage may destroy the motor.
•
Perform a final test and verify that the device operates correctly on the window frame, moving the pawl
of the sliding accessory sideways.
•
Power the device and move the pawl to the Open position; the hook of the actuator must slide towards
the center of the machine.
•
Close the sash of the window or door.
8.2.4.
Drilling for external assembly
▪
Determine the drilling points for the linear actuator (the metal one) that corresponds with a pawl of the
sliding accessory to be moved, and mark it with a pencil. The measurements are provided in the drawing
below.
▪
Drill the window frame in the points marked with the diameters indicated in the drawings and clean the
edges of any burr.
▪
Check (by overlapping them) that the actuator is positioned correctly and the hook (in the closed
position) is aligned with the pawl of the closed sliding accessory.
▪
Check that the electrical cable path is free of obstacles; otherwise eliminate them.
27