Important Safety Information; Electrical Requirements; Grounding Instructions - Danby DAC150BGUWDB Manual Del Propietário

Important Safety Information

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

ELECTRICAL REQUIREMENTS

All wiring must comply with local and national
codes and must be installed by a qualifi ed
electrician. Check the available power supply and
resolve any wiring problems before installing and
operating this appliance.
The rating plate located on the right side of the
appliance just above the power cord contains
electrical and other technical data.
This appliance is not designed for "through the
wall" installation.

GROUNDING INSTRUCTIONS

This appliance must be grounded. Grounding
reduces the risk of electrical shock by providing an
escape wire for the electrical current.
This appliance has a cord that has a grounding
wire with a 3-prong plug. The power cord must be
plugged into an outlet that is properly grounded.
If the outlet is a 2-prong wall outlet, it must be
replaced with a properly grounded 3-prong wall
outlet.
WARNING - Improper use of the grounding
plug can result in a risk of electric shock.
Consult a qualifi ed electrician or service agent
if the grounding instructions are not completely
understood, or if doubt exists as to whether the
appliance is properly grounded.
Do not connect your appliance to extension cords
or together with another appliance in the same
wall outlet.
Do not splice the power cord. Do not under any
circumstances cut or remove the third ground prong
from the power cord. Do not use extension cords or
ungrounded (two prongs) adapters.
If the power supply cord is damaged, it must be
replaced by the manufacturer, its service agent or
similar qualifi ed person in order to avoid hazard.
POWER SUPPLY CORD
The power cord contains a device that senses
damage to the power cord. To test if the power cord
is working properly:
1. Connect the power supply cord to an electrical
2. The power supply cord has two buttons located
3. Press the "Reset" button and a click will sound as
4. The power supply cord is now energized and
Notes:
• If the appliance looses power, the reset button
• This button should not be used to turn the
• The "Reset" button must always be pushed in for
• The power supply cord must be replaced if it
POWER RECEPTACLES
These appliances require higher voltage receptacles
than standard household receptacles. Consult the
table below to fi nd the required receptacle for your
model number.
SAVE THESE INSTRUCTIONS!
2
outlet.
on the head of the plug. One button is marked
"Test" and the other is marked "Reset". Press the
"Test" button and the "Reset" button will pop out
and click.
the button engages.
supplying electricity to the appliance.
may need to be reengaged when the power
resumes.
appliance on and off.
correct operation.
fails to reset when the "Test" button is pushed in.
Model Number
DAC150BGUWDB
DAC180BGUWDB
DAC250BGUWDB
Voltage Receptacle
125
240
240