Getting Started; Preparing The Remote - Sony SCD-X501ES Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Getting Started

Preparing the remote

Pull out the insulating sheet to allow power
to flow from the battery.
The remote already contains a battery.
Replacing the battery in the
remote
1
Slide out the battery case in the direction of
arrow 2 by pushing the lock in the direction
of arrow 1 and then remove the battery
from the battery case.
2
Insert a new lithium battery CR2025 with the
+ side facing up.
3
Slide the battery case back in.
Note
If you do not use the remote for a long period of time,
remove the battery to avoid possible damage from
battery leakage and corrosion.
GB
6
A lithium battery CR2025
Notes on lithium battery
• Keep the lithium battery out of the reach of children.
Should the battery be swallowed, immediately
consult a doctor.
• Wipe the battery with a dry cloth to assure a good
contact.
• Be sure to observe the correct polarity when
installing the battery.
• Do not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
Note
Do not expose the remote sensor
or lighting apparatus. Doing so may cause a
malfunction.
Tip
When the remote can no longer operate the system,
replace the battery with a new one.
WARNING
Battery may explode if you mistreated.
Do not recharge, disassemble or dispose of in fire.
to direct sunlight

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido