Twin-Star International 36WM1512 Manual De Instrucciones Adjunto página 5

PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and diagram above. If any part is missing or damaged, do not attempt to
assemble, install or operate the product. Contact customer service for replacement parts.
Estimated Assembly Time: 60 Minutes
Tools Required for Assembly (not included): Phillips head screwdriver, scissors and utility knife
ASSEMBLY INSTRUCTIONS
1. Locate the Center Lower Front Panel (H), Right
Front Panel (C) and Left Front Panel (B) and set out
face down on a scratch-free surface.
Insert one Wood Dowel (CC) into each of the
pre-drilled holes, Push the Right Front Panel (C) and
Left Front Panel (B) snug to the Center Lower Front
Panel (H). Make sure the Wood Dowels are seated
in the pre-drilled holes.
Connect the Left Front Panel (B), Right Front Panel
(C) and Center Lower Front Panel (H) with
connection plate, tighten screws (II) through the
pre-drilled holes.
HAND TIGHTEN ONLY.
Hardware Used
CC Wood Dowel
II
Screw
2. Locate Hearth/Base (A) and set out finished side up
on the floor.
Insert one Wood Dowel (CC) into each of the
pre- drilled holes.
Attach the completed Front panel assembly from
step 1 and Center Support Panel (J) to the
Hearth/Base (A). Make sure the dowels are seated
into the pre-drilled holes in the Hearth/Base. Using
Bolts (AA) and Washers (BB) attach panels through
pre-drilled holes in the mounting blocks.
HAND TIGHTEN ONLY.
Hardware Used
AA Bolt
BB
Washer
CC Wood Dowel
Fig. 1
x 4
CC
x 2
Fig. 2
x 8
x 8
x 10
4
II
C
H
AA
BB
A
J
CC
B
CC
CC